INA, INA Datasheet, INA MicroPower Instrumentation Amplifier Datasheet, buy INA The INA and INA are precision instrumentation ampli- fiers for semiconductor products and disclaimers thereto appears at the end of this data sheet. INAU ti INA, Micropower Instrumentation Amplifier Single And Dual Versions. DESCRIPTION. Details, datasheet, quote on part number: INAU .
|Published (Last):||13 June 2009|
|PDF File Size:||7.15 Mb|
|ePub File Size:||12.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
May I know if my circuits are correct? I tried your suggestion but I’m still getting the same problem: This will make the first subcircuit in the text a subcircuit named INAP, ending with the “extra”.
amplifier ina, single power supply, saturation – Raspberry Pi Forums
I think the first circuit is ok. Either circuit should work. Message 16 of I have used the AD chip successfully in the past with good results.
The issue is actually with daatasheet differences between the symbol that you used as the template for the INA and the expected symbol. Hello all Mulstim users. Message 18 of Message 12 of I have also created another component, but not wroking also. I’ve done that in two ways: This question does not appear to be about programming within the scope defined in the help center.
It looks like the 3rd. I’m also sending my file so you can also have a look.
I would perhaps use both in conjunction with one another. Message 15 of I would suggest that the easiest way to get the pin setup as expected is to create the component using the INA in the master database as the starting symbol since it has the pin names and numbers matching datassheet INA data sheet, just with a different model.
I’m attaching the model file I’ve used with the suggested changes. I also tried changing the symbol to model pins but that also didn’t work, it just made it worst. Then you’ll be able to wire it up exactly as you expect to be able to, and the behaviour should be what you expect.
So I tried to add an offset to the thermocouple input. Lorenzo Donati 5, 4 28 And the 1K’s could probably be 10K, if you want to save some current.
Now everything is working well and I can carry on with my simulations. I tried making all possible connections between pins 1, 8 and 5 and that still didn’t help. Message 11 of The main point is to have the subcircuit that you want the component to use directly as the top. If you have any questions, let us know!
Since it will be the first thing in the listing, Multisim will see an 8 pin subcircuit, which just uses the 8-pin INAP defined below which in turn uses the other two op-amp subcircuits.