AXP202 DATASHEET PDF

AXP comprises an adaptive USB-Compatible PWM charger, 2 BUCK DC-DC converters, 5 LDOs, multiple bit ADCs of Voltage, current and temperature. AXP Datasheet, AXP PDF, AXP Data sheet, AXP manual, AXP pdf, AXP, datenblatt, Electronics AXP, alldatasheet, free, datasheet. AXP datasheet, AXP circuit, AXP data sheet: ETC2 – Single Cell Li- Battery PWM Charger and Power System Management IC,alldatasheet.

Author: Tegul Bat
Country: Suriname
Language: English (Spanish)
Genre: Politics
Published (Last): 11 February 2011
Pages: 367
PDF File Size: 6.26 Mb
ePub File Size: 1.3 Mb
ISBN: 493-1-13698-641-8
Downloads: 2469
Price: Free* [*Free Regsitration Required]
Uploader: Milabar

PDF AXP202 Datasheet ( Hoja de datos )

GPIO output low When an interrupt is fired and the interrupt line datqsheet pulled low, bit 7 of 0x48 will be set to 1. DC-DC mode selection 8.

Indicate the charging current is less than the desired current 0: Additionally, the interrupt status bit is also used to clear the interrupt, so that it can fire again. The datasehet current mode timeout setting Bit TS pin function selection 0: Coulomb Counter Control 8. Indicates that the battery current direction 0: Charge VBUS charge feature set 0: V LTF-charge Charging the battery temperature threshold set 8. Battery is no longer charging in activation mode.

  6160CR 2 PDF

For example, register 0x40 bit 7, ACIN Over-voltage, can be enabled or disabled by writing a 1 into bit 7 of reg 0x V LTF-discharge Battery discharge temperature threshold set 8. LDO3 voltage rate control 1: Battery activation mode may indicate that the battery is faulty. On when charging ADC sample rate settings, the TS pin control 8. On when ADC enabled Disconnect VBUS charge resistor; 1: GPIO0 feature set 8. GPIO output high 3.

AXP202 Datasheet PDF

The AXP interrupt system has 2 bits for every interrupt, offset by 8 bytes. Battery charging in activation mode. This mode is entered either from pre-charge mode or constant current mode under certain conditions.

LDO3 output voltage setting Apx202 0. Coulomb Counter pause control, the write will be suspended Coulomb counting while this bit is cleared from. Content is available under Creative Commons Attribution unless otherwise noted. ADC Enable 2 8.

Retrieved from ” http: DC-DC2 output voltage setting 8. LDO3 output voltage settings 8. The battery state of existence indicates 0: The datasheet is incorrect here.

  BEAVERDALE WINE INSTRUCTIONS PDF

The actual charge current is equal to the desired current; 1: Interrupt bank 1; Input power 8.

AXP 데이터시트(PDF) – List of Unclassifed Manufacturers

Interrupt bank 4 8. To clear this interrupt, write a 1 into bit 7 of 0x Interrupt bank 2; Battery 8.

Charging the end of the current set 0: Discharge VBUS discharge feature set 0: