ASTM D() Standard Test Methods for Visually Inspecting and Grading Fabrics Scope These test methods describe a procedure to. Four-Point System: Four-Point System, a standard established under ASTM D – 07(), is a standardized Test Methods for fabric. Home; ASTM D(). standard by ASTM International, 07/ 15/ View all product details ASTM D(). March
|Published (Last):||22 January 2008|
|PDF File Size:||20.44 Mb|
|ePub File Size:||5.44 Mb|
|Price:||Free* [*Free Regsitration Required]|
August 26, Md Sohanur Rahman Sobuj 0. A check sheet includes general details, details of fabric lot, fabric defects according their sizes, summary of d5340-93 defects, quantity inspected and total penalty points and result of the fabric lot after inspection.
Major knitted fabric defects.
Fabric Inspection | Four Point System
Omar Faruk see all. Bar tack Sewing Machine II Study on bar tack sewing machine with thread path diagram and sample production. Disperse Dye for Polyester Why called disperse dye Application and r5430-93 of disperse dyes Features of of disperse dyes October 15, Fatema Sharmin 0. One more thing atm should remember that acceptable points can be defined as points per linear yards as well as points per square yards. Pieces having a width of measurement of less than the specified purchased width shall be graded as second quality.
Only major errors are considered. There are various fabric inspection systems such as.
Fabric Inspection | Four Point System | Textile Study Center
No penalty points are assigned to minor defects. The Quality Inspector may include any other defect which he feels are of a major category and may forward such defect details to the customer for feed back as and when required. A fabric roll yards long and 46 inch wide contains following defects.
Some fabric defects are given below:.
Again grading is done based number of penalty points per square yards. To use this system someone have to know following things: Latest posts by Md. Secondly, acceptable points for individual roll and acceptable average points of all roll are set at different level.
Fabric width will be checked minimum of three times during the inspection of a satm beginning, middle and end of a piece. Major woven fabric defects. Major dye or printing defects. This width is excluding selvedge. A defect can be measured either length or width direction; the system remains the same.
ASTM D – 93() Standard Test Methods for Visually Inspecting and Grading Fabrics
Fabric checker should know common defects found in fabrics and he must recognize defects on the fabric at the time of fabric inspection. Progressive Bundle System April 7, Md. Following defects are cut table and will be rejected: Many used to d540-93 that up to 40 points per square yards is acceptable. A sample 4 point system fabric inspection format has been attached at the bottom. Holes and openings the largest dimension. Fabric Inspection Four point system.
Check sheet or Inspection Format. Only major defects are taking into account. No more than 4 penalty points is assigned for any single flaw.
No penalty points are recorded or assigned for minor defects. So, defect is acceptable. Four-Point System is widest acceptance in fabric inspection due to its practical, impartial, and worldwide recognized.
A standards level is set by ASTM.